User Manual
Table Of Contents
- Chapter 1 Introduction
- 1.1 Package Contents
- Chapter 2 Installation
- 2.1 Installing the CPU
- 2.2 Installing the CPU Fan and Heatsink
- 2.3 Installing Memory Modules (DIMM)
- 2.4 Expansion Slots (PCI Express Slots)
- 2.5 Jumpers Setup
- 2.6 Onboard Headers and Connectors
- 2.7 Dr. Debug
- 2.8 SLITM and Quad SLITM Operation Guide
- 2.9 CrossFireXTM and Quad CrossFireXTM Operation Guide
- 2.10 M.2_SSD (NGFF) Module Installation Guide
- Chapter 3 Software and Utilities Operation
- Chapter 4 UEFI SETUP UTILITY
English
37
Fatal1ty X370 Gaming X Series
2.9 CrossFireX
TM
and Quad CrossFireX
TM
Operation Guide
is motherboard supports CrossFireX
TM
and Quad CrossFireX
TM
that allows you
to install up to two identical PCI Express x16 graphics cards.
2.9.1 Installing Two CrossFireX
TM
-Ready Graphics Cards
Step 1
Insert one graphics card into PCIE2 slot
and the other graphics card to PCIE3 slot.
Make sure that the cards are properly
seated on the slots.
Step 2
Connect two graphics cards by installing
a CrossFire Bridge on the CrossFire Bridge
Interconnects on the top of the graphics
cards. (e CrossFire Bridge is provided
with the graphics card you purchase, not
bundled with this motherboard. Please
refer to your graphics card vendor for
details.)
1. You should only use identical CrossFireX
TM
-ready graphics cards that are AMD certied.
2. Make sure that your graphics card driver supports AMD CrossFireX
TM
technology.
Download the drivers from the AMD’s website: www.amd.com
3. Make sure that your power supply unit (PSU) can provide at least the minimum power
your system requires. It is recommended to use a AMD certied PSU. Please refer to the
AMD’s website for details.
4. If you pair a 12-pipe CrossFireX
TM
Edition card with a 16-pipe card, both cards will oper-
ate as 12-pipe cards while in CrossFireX
TM
mode.
5. Dierent CrossFireX
TM
cards may require dierent methods to enable CrossFireX
TM
.
Please refer to AMD graphics card manuals for detailed installation guide.
CrossFire Bridge