User Manual
Table Of Contents
- Chapter 1 Introduction
- 1.1 Package Contents
- Chapter 2 Installation
- 2.1 Installing the CPU
- 2.2 Installing the CPU Fan and Heatsink
- 2.3 Installing Memory Modules (DIMM)
- 2.4 Expansion Slots (PCI and PCI Express Slots)
- 2.5 Jumpers Setup
- 2.6 Onboard Headers and Connectors
- 2.7 CrossFireXTM and Quad CrossFireXTM Operation Guide
- 2.7.1 Installing Two CrossFireXTM-Ready Graphics Cards
- 2.7.2 Driver Installation and Setup
- 2.8 M.2_SSD (NGFF) Module Installation Guide
- Chapter 3 Software and Utilities Operation
30
English
2.9 M.2_SSD (NGFF) Module Installation Guide (M2_1)
e M.2, also known as the Next Generation Form Factor (NGFF), is a small size and
versatile card edge connector that aims to replace mPCIe and mSATA. e Ultra M.2
Socket (M2_1) supports M.2 SATA3 6.0 Gb/s module and M.2 PCI Express module up to
Gen3 x4 (32 Gb/s).
* If M2_1 is occupied by a SATA-type M.2 device, SATA3_5 will be disabled.
Installing the M.2_SSD (NGFF) Module
Step 1
Prepare a M.2_SSD (NGFF) module
and the screw.
3
2
4
BCD
A
1
Step 2
Depending on the PCB type and
length of your M.2_SSD (NGFF)
module, nd the corresponding nut
location to be used.
No. 1 2 3 4
Nut Location A B C D
PCB Length 3cm 4.2cm 6cm 8cm
Module Type Type2230 Type 2242 Type2260 Ty pe 2280