Other Content

7. Select the volume size and press Enter.

8. Press Enter to create the volume.

9. At the prompt press Y to confirm volume creation.

10. Select 4: Exit and press Enter.

11. Press Y to confirm your exit.

Install the RAID Driver Using the F6 Installation Method

Perform the following steps to install the Intel Rapid Storage Technology driver

during operating system setup:

1. Press F6 when you see a message in the status line that says, Press F6 if you

need to install a third party SCSI or RAID driver. This message appears at

the beginning of Windows

setup (during text-mode phase).

Note

Nothing will happen immediately after pressing F6. Setup will

temporarily continue loading drivers. You will then be prompted

with a screen asking you to load support for mass storage

device(s).

2. Press S to Specify Additional Device.

3. When you see a prompt that says, Please insert the disk labeled

Manufacturer-supplied hardware support disk into Drive A:, insert ;a floppy

disk containing the following files: IAAHCI.INF, IAAHCI.CAT, IASTOR.INF,

IASTOR.CAT, IASTOR.SYS, and TXTSETUP.OEM.

Note

Use the Floppy Configuration Utility to create a floppy disk with the

necessary files.

4. Press Enter.

5. Select your controller from the list of available SCSI adapters. Use the up

and down arrow keys to scroll through the list as all controllers may not be

visible.

6. Press Enter to confirm your controller and continue. At this point, you have

successfully installed the driver and Windows setup should continue. Leave