User's Manual
Table Of Contents
- FCC and IC statements
- 1. Introduction
- 2. To mount the encoder
- 3. Electrical specification
- 4. To connect to Visionline or VingCard Vision
- 5. Configuration utility
- 6. To factory reset the encoder
- 7. Web interface (Visionline only)
- Appendix A: Quick reference of technical data
- Appendix B: To install the USBXpress driver
- Appendix C: To upgrade firmware
- Appendix D: Boot-up procedure
- Appendix E: More about how the encoder finds the server (Visionline only)
- Revision history
13
ASSA ABLOY Hospitality
66 1001 001-7
4.1.3 RFID encoder in SysMon
Figure 9
1. Double click on SysMon.exe in
the Visionline installation folder.
2. Go to View/RFID Encoders;
encoders that have been connected
via TCP/IP will be shown. Note:
When hovering over an RFID
encoder in the RFID Encoders
window of SysMon, information
about Mac address, IP address,
firmware version and last ping
will be shown.
Note: For upgrade of firmware
via SysMon, see Appendix C.
4.1.3.1 To rename the encoder
Figure 10
1. To rename an encoder,
right click on it in SysMon
and choose Edit Name.
Figure 11
2. The dialog in Figure 11 will be
shown; enter a name for the
encoder and click OK.