User's Manual
Table Of Contents
- FCC and IC statements
- 1. Introduction
- 2. To mount the encoder
- 3. Electrical specification
- 4. To connect to Visionline or VingCard Vision
- 5. Configuration utility
- 6. To factory reset the encoder
- 7. Web interface (Visionline only)
- Appendix A: Quick reference of technical data
- Appendix B: To install the USBXpress driver
- Appendix C: To upgrade firmware
- Appendix D: Boot-up procedure
- Appendix E: More about how the encoder finds the server (Visionline only)
- Revision history
16
ASSA ABLOY Hospitality
66 1001 001-7
5.1 To configure the encoder for use with Visionline
Figure 13
1. Make sure that the USBXpress driver is installed;
see Appendix B for details.
2. Double click on RFIDEncoderConfig.exe.
3. Connect the encoder to USB power; the encoder will
appear in the drop-down-menu at 'USB' in the upper
left corner of the RFID Encoder Configuration
Utility window.
4. Select the encoder in the drop-down-menu.
5. Click the Start button to connect.
Figure 14
6. Click the Get version button.
Figure 15
7. The firmware version of the encoder will be shown;
make sure that it is the latest version, if not upgrade
the encoder according to Appendix C.