User's Manual
Table Of Contents
- FCC and IC statements
- 1. Introduction
- 2. To mount the encoder
- 3. Electrical specification
- 4. To connect to Visionline or VingCard Vision
- 5. Configuration utility
- 6. To factory reset the encoder
- 7. Web interface (Visionline only)
- Appendix A: Quick reference of technical data
- Appendix B: To install the USBXpress driver
- Appendix C: To upgrade firmware
- Appendix D: Boot-up procedure
- Appendix E: More about how the encoder finds the server (Visionline only)
- Revision history
17
ASSA ABLOY Hospitality
66 1001 001-7
Figure 16
8. Click the Get config button. At first configuration, the
default encoder parameters will be shown; see Figure
16. Note: The default parameter values are also shown
in section 6.1.
Figure 17
9. To modify one or more parameters, make the desired
changes and click the Set config button.
Figure 18
10.When the new configuration has bee set in the
encoder, a message as in Figure 18 will be shown.