User's Manual
Table Of Contents
- FCC and IC statements
- 1. Introduction
- 2. To mount the encoder
- 3. Electrical specification
- 4. To connect to Visionline or VingCard Vision
- 5. Configuration utility
- 6. To factory reset the encoder
- 7. Web interface (Visionline only)
- Appendix A: Quick reference of technical data
- Appendix B: To install the USBXpress driver
- Appendix C: To upgrade firmware
- Appendix D: Boot-up procedure
- Appendix E: More about how the encoder finds the server (Visionline only)
- Revision history
19
ASSA ABLOY Hospitality
66 1001 001-7
Figure 22
8. Click the Get config button. At first configuration, the
default encoder parameters will be shown; see Figure
22. Note: The default parameter values are also shown
in section 6.1.
Figure 23
9. Under IP Setup:
- uncheck Dynamic IP address (DHCP)
- set Host IP address; this is the
encoder IP address
- set Default gateway; this is the
encoder gateway address
- set Subnet mask; this is the
encoder subnet mask
10.Under Connection Setup:
- uncheck Announcement broadcast
- let Server IP and Server Port be
empty; these parameters are not
applicable for VingCard Vision
- let KDE port be 3001
11.Under Misc Settings:
- check Emulate KDE
- uncheck the rest of the checkboxes
12.Click the Set config button.
Figure 24
13.When the new configuration has been set in the
encoder, a message as in Figure 24 will be shown.
14.Disconnect the power and USB cables.
15.Connect the LAN cable to the local hub.
16.Power up the encoder.