User's Manual
Table Of Contents
- FCC and IC statements
- 1. Introduction
- 2. To mount the encoder
- 3. Electrical specification
- 4. To connect to Visionline or VingCard Vision
- 5. Configuration utility
- 6. To factory reset the encoder
- 7. Web interface (Visionline only)
- Appendix A: Quick reference of technical data
- Appendix B: To install the USBXpress driver
- Appendix C: To upgrade firmware
- Appendix D: Boot-up procedure
- Appendix E: More about how the encoder finds the server (Visionline only)
- Revision history
2
ASSA ABLOY Hospitality
66 1001 001-7
Copyrights
The information in this document is subject to change at the sole discretion of
ASSA ABLOY without notice.
Any use, operation or repair in contravention of this document is at your own risk.
ASSA ABLOY does not assume any responsibility for incidental or consequential
damages arising from the use of this manual.
All information and drawings in this document are the property of ASSA ABLOY.
Unauthorized use and reproduction is prohibited.
VingCard and Elsafe are registered trademarks of ASSA ABLOY.