User's Manual

20
ASSA ABLOY Hospitality
66 1001 001-7
6. To factory reset the encoder
There are two ways to reset the encoder parameters to default values, e.g. if an
encoder should be used at a demo installation:
Press and hold the F button with a narrow instrument while powering up the
encoder; see in Figure 5 where the button is located.
Press Defaults and then Set config in the RFID Encoder Configuration Utility;
see below for details. The default values are also shown in Table 3.
Figure 25
1. Click the Defaults button.
Figure 26
2. If the default parameters should be set in the
encoder, click the Set config button. Note: If
VingCard Vision is applicable, it will not be possible
to connect to the encoder after the default values
have been set in it. In this case, the encoder must
then be reconfigured according to section 5.2; make
sure that Emulate KDE is checked in RFID
Encoder Configuration Utility.