User's Manual
Table Of Contents
- FCC and IC statements
- 1. Introduction
- 2. To mount the encoder
- 3. Electrical specification
- 4. To connect to Visionline or VingCard Vision
- 5. Configuration utility
- 6. To factory reset the encoder
- 7. Web interface (Visionline only)
- Appendix A: Quick reference of technical data
- Appendix B: To install the USBXpress driver
- Appendix C: To upgrade firmware
- Appendix D: Boot-up procedure
- Appendix E: More about how the encoder finds the server (Visionline only)
- Revision history
21
ASSA ABLOY Hospitality
66 1001 001-7
6.1 Default parameter values
Note: For a description of the encoder parameters, see Table 2.
Parameter
Default value
Dynamic IP address (DHCP; Dynamic Host Configuration
Protocol)
Enable
Host IP
192.168.0.100
Default gateway
192.168.0.1
Subnet mask
255.255.255.0
Announcement broadcast
Enable
Server port
7799
KDE port
3001
Emulate KDE
Disable
Wall mounted
Disable
Zero config
Enable
EPHY auto negotiate
Enable
Table 3: Default parameter values for the RFID encoder