User's Manual
Table Of Contents
- FCC and IC statements
- 1. Introduction
- 2. To mount the encoder
- 3. Electrical specification
- 4. To connect to Visionline or VingCard Vision
- 5. Configuration utility
- 6. To factory reset the encoder
- 7. Web interface (Visionline only)
- Appendix A: Quick reference of technical data
- Appendix B: To install the USBXpress driver
- Appendix C: To upgrade firmware
- Appendix D: Boot-up procedure
- Appendix E: More about how the encoder finds the server (Visionline only)
- Revision history
23
ASSA ABLOY Hospitality
66 1001 001-7
Appendix A: Quick reference of technical data
Dimensions, encoder (WxHxD):
83.3 x 152.0 x 42.2 mm (3 9/32" x 5 31/32" x 1 21/32")
Dimensions, card holder (WxHxD):
88.7 x 85.8 x 48.0 mm (3 1/2" x 3 3/8" x 1 57/64")
Material in encoder: ABS UL 94V-0
Automatic adjustment to 10 or 100MBit/s networks
Material in card holder: PC UL 94V-0, semitransparent
Several possibilities for powering:
- Power via PoE; power over Ethernet
Note: The RFID encoder is of PoE class 1; power range 0.44-3.84W.
- External power via adapter of 5VDC regulated voltage
- Power via USB (only applicable for Visionline)
The maximum current consumption for the RFID encoder is
400 mA continuously
Sound signals
Intended for indoor use only, temperature range +5ºC to +50ºC
Relative humidity 10-90%; non-condensing
Required version of Visionline: 1.11.1 or higher
Required version of VingCard Vision: 5.2 or higher