User's Manual
Table Of Contents
- FCC and IC statements
- 1. Introduction
- 2. To mount the encoder
- 3. Electrical specification
- 4. To connect to Visionline or VingCard Vision
- 5. Configuration utility
- 6. To factory reset the encoder
- 7. Web interface (Visionline only)
- Appendix A: Quick reference of technical data
- Appendix B: To install the USBXpress driver
- Appendix C: To upgrade firmware
- Appendix D: Boot-up procedure
- Appendix E: More about how the encoder finds the server (Visionline only)
- Revision history
25
ASSA ABLOY Hospitality
66 1001 001-7
Appendix C: To upgrade firmware
To upgrade firmware via RFID Encoder Configuration Utility
Figure C1
1. Double click on
RFIDEncoderConfig.exe.
2. Connect the encoder to USB power;
the encoder will appear in the drop-
down-menu at 'USB'.
3. Select the encoder in the drop-
down-menu.
4. Click the Start button.
5. Click the Open button.
Figure C2
6. Browse to the desired firmware file
and click Open.
Figure C3
7. When the firmware version has
been loaded, it will be shown next
to the Bootload button as shown
in Figure C3.