User's Manual
Table Of Contents
- FCC and IC statements
- 1. Introduction
- 2. To mount the encoder
- 3. Electrical specification
- 4. To connect to Visionline or VingCard Vision
- 5. Configuration utility
- 6. To factory reset the encoder
- 7. Web interface (Visionline only)
- Appendix A: Quick reference of technical data
- Appendix B: To install the USBXpress driver
- Appendix C: To upgrade firmware
- Appendix D: Boot-up procedure
- Appendix E: More about how the encoder finds the server (Visionline only)
- Revision history
26
ASSA ABLOY Hospitality
66 1001 001-7
Figure C4
8. Click the Bootload button.
Figure C5
9. When the bootloading has finished,
a message as in Figure C5 will be
shown.
To upgrade firmware via SysMon
(only applicable for Visionline)
Figure C6
1. Double click on SysMon.exe in
the Visionline installation folder.
2. Go to View/RFID Encoders;
encoders that have been
connected via TCP/IP will be shown.
3. Mark the applicable encoder and click
the Set button; choose Set
Firmware Files for Bootloading.
Figure C7
4. The dialog in Figure C7 will
be shown.
5. Click the Browse button
at the applicable one of ’RFID
Encoder’ or ‘RFID Encoder w ext
memory’ and select the applicable
encoder firmware file.
6. Click OK in the Select Firmware
Files for Bootload dialog.