User's Manual
Table Of Contents
- FCC and IC statements
- 1. Introduction
- 2. To mount the encoder
- 3. Electrical specification
- 4. To connect to Visionline or VingCard Vision
- 5. Configuration utility
- 6. To factory reset the encoder
- 7. Web interface (Visionline only)
- Appendix A: Quick reference of technical data
- Appendix B: To install the USBXpress driver
- Appendix C: To upgrade firmware
- Appendix D: Boot-up procedure
- Appendix E: More about how the encoder finds the server (Visionline only)
- Revision history
6
ASSA ABLOY Hospitality
66 1001 001-7
1. Introduction
The RFID encoder is used for encoding and verifying RFID cards. It can be used
together with the below systems:
Visionline
VingCard Vision
Unless anything else is stated, the information in this document is valid for
both systems.
Note: For upgrade of firmware in the RFID encoder, see Appendix C.
Figure 1: RFID encoder