User's Manual
Table Of Contents
- FCC and IC statements
- 1. Introduction
- 2. To mount the encoder
- 3. Electrical specification
- 4. To connect to Visionline or VingCard Vision
- 5. Configuration utility
- 6. To factory reset the encoder
- 7. Web interface (Visionline only)
- Appendix A: Quick reference of technical data
- Appendix B: To install the USBXpress driver
- Appendix C: To upgrade firmware
- Appendix D: Boot-up procedure
- Appendix E: More about how the encoder finds the server (Visionline only)
- Revision history
8
ASSA ABLOY Hospitality
66 1001 001-7
2.2 Mounting kit
The RFID encoder is delivered with a mounting kit containing the following items:
Description
Quantity
Usage
Screws 2,9x25mm
2
For mounting the RFID encoder on a wall
Collar screw 3,5x25mm
1
For mounting the RFID encoder on a wall
Screws 2,5x6,4mm
4
For mounting the card holder and mounting brackets
Expand plugs 6x30
3
Mounting brackets
2
Adhesive Velcro strips
2
If the RFID encoder should be mounted without using screws
Table 1: Mounting kit
2.3 To mount on the wall
The encoder can be mounted on the wall either with the enclosed screws or with
the enclosed Velcro strips.
If the encoder should be mounted with screws:
fasten the mounting brackets at the bottom of the encoder with the two
mounting bracket screws
fasten the encoder on the wall with the collar screw at the suspension and
two screws at the mounting brackets
Figure 3: Exploded view of RFID encoder,
card holder and mounting details
Note: When mounting the encoder on the wall, the parameter 'Wall mounted'
must be enabled; this can be done via the RFID Encoder Configuration Utility
(see chapter 5). If Visionline is applicable, it can also be done via the web
interface (see chapter 7).