User's Manual
Table Of Contents
- FCC and IC statements
- 1. Introduction
- 2. To mount the encoder
- 3. Electrical specification
- 4. To connect to Visionline or VingCard Vision
- 5. Configuration utility
- 6. To factory reset the encoder
- 7. Web interface (Visionline only)
- Appendix A: Quick reference of technical data
- Appendix B: To install the USBXpress driver
- Appendix C: To upgrade firmware
- Appendix D: Boot-up procedure
- Appendix E: More about how the encoder finds the server (Visionline only)
- Revision history
9
ASSA ABLOY Hospitality
66 1001 001-7
2.4 Card holder
If the RFID encoder is mounted on the wall, a card holder should be mounted on
the encoder. The card holder, including two screws for fixation, are enclosed with
the encoder at delivery.
Figure 4: The card holder is snapped onto the RFID encoder
and also fastened with two screws.