User's Manual
Table Of Contents
- FCC and ISED (IC) statements
- 1. Introduction
- 1.1 Orion EMS devices
- 1.2 Terminology
- 1.3 General about Orion Service
- 1.4 General about alarms
- 1.5 Events and commands
- 1.6 Basic EMS logic
- 1.7 Orion EMS parameters
- 1.8 Operator templates
- 1.9 Setback override
- 2. Thermostat buttons and display
- 3. Energy management summary and alarm list
- 4. Real time room status
- 5. Thermostats list
- 6. Occupancy report
- 7. Energy statistics report
- 8. Tools/Options
- 9. Orion EMS in SysMon
- 10. Maintenance
- Appendix A: Quick reference of technical data
- Appendix B: Troubleshooting
- Appendix C: Read more
- Revision history
25
ASSA ABLOY Hospitality
66 8003 015-3
1.9 Setback override
The Orion EMS features may be overridden when needed, e.g. for VIP guests where
no setbacks should apply. Setback override may be enabled until the room is unsold or
until a certain time; if desired, until further notice.
Note: Override mode can also be set from Orion Service; see Quick reference guide
Orion Service for details. If the override mode has been set from Orion Service, it must
also be cleared from Orion Service. If the override mode has been set from the Change
thermostat settings dialog as below in this section, it can however be cleared either
from Orion Service or from the Change thermostat settings dialog.
1. Double click on
Thermostats under
the Lists tab in the
navigation window.
2. Mark the applicable
thermostat and click
Status.
Figure 11
3. In the Thermostat
status dialog, click
the Set button.
Figure 12