User's Manual
Table Of Contents
- FCC and ISED (IC) statements
- 1. Introduction
- 1.1 Orion EMS devices
- 1.2 Terminology
- 1.3 General about Orion Service
- 1.4 General about alarms
- 1.5 Events and commands
- 1.6 Basic EMS logic
- 1.7 Orion EMS parameters
- 1.8 Operator templates
- 1.9 Setback override
- 2. Thermostat buttons and display
- 3. Energy management summary and alarm list
- 4. Real time room status
- 5. Thermostats list
- 6. Occupancy report
- 7. Energy statistics report
- 8. Tools/Options
- 9. Orion EMS in SysMon
- 10. Maintenance
- Appendix A: Quick reference of technical data
- Appendix B: Troubleshooting
- Appendix C: Read more
- Revision history
40
ASSA ABLOY Hospitality
66 8003 015-3
default 0 hours is used, there is no limitation in time for the setback override
and it can be set until further notice.
5. Unit: The temperature unit (Fahrenheit/Celsius).
Note: Changes to the temperature unit will be broadcasted to all thermostats.
8.2 Maintenance
At Tools/Options/Energy management/Maintenance, it is possible to specify
three different thermostat maintenance intervals in hours; 0-65535 hours. This is
the number of hours of runtime that should pass before an alarm is triggered. It is also
possible to rename the three maintenance intervals.
Maintenance counter 1 is for fan time/total HVAC time
Maintenance counter 2 is for ‘cooling’
Maintenance counter 3 is for ‘cooling or heating’
Figure 31
1. Enter the applicable maintenance value(s) in hours.
2. If applicable, rename the three maintenance counters to your needs.
3. Click OK.