User's Manual
Table Of Contents
- FCC and ISED (IC) statements
- 1. Introduction
- 2. Installing the option
- 3. Installing online devices
- 4. Online settings in the client
- 5. Issuing a ZigBee configuration card
- 6. System operation
- 7. Commissioning
- 8. Power loss and hardware failure
- 9. Redundancy and recovery
- Appendix A: Online devices
- Appendix B: Mounting of gateway and router
- Appendix C: Example configurations
- Appendix D: Web interface for gateway
- Appendix E: Reset of gateway
- Appendix F: Gateway boot-up
- Appendix G: More about how the gateway finds the server
- Appendix H: Firmware upgrade
16
ASSA ABLOY Hospitality
66 3081 004-23
2. Installing the option
If the option has been ordered together with the software, it is included in the license
code and will be set in the software when the license code is entered.
If the option should be added to the system at a later occasion, when the license code
has already been entered and system ID is therefore set, an option code is used instead.
Several software options can be included in one option code. An operator with the
authority to handle option codes must be logged on. Normally, options are set by the
system manager or the distributor.
When ordering the option, the system code must be communicated to the
ordering department:
1. Double click on System settings under the Reports tab in the navigation
window to find the system code. System settings is available even if you are not
logged on.
2. Communicate your system code to the order department; see order
acknowledgement for phone number and e-mail address. The system code can also
be entered in the Ordering web page when making the order.
To install the option:
1. When you have got your option code, go to Tools/Option code.
2. Enter the option code and click Apply.
Figure 8