User's Manual

18
ASSA ABLOY Hospitality
66 3081 004-23
3.1 Installing a server
The application server must be connected to the same network that the
GW devices will be connected to.
The application server must have the online option installed; see chapter 2
for details.
1. Before you install the first GW device, you must add a ZigBee gateway to the
device list in the software (double click on Devices under the Lists tab in the
navigation window and click Add to add a new device) using the following
parameters:
Figure 9
2. When the fields have been filled in according to Figure 9 (port 7799 is pre-filled
as default when choosing 'ZigBee gateway' at Type), click Save and Close.
Note: If desired, mark the checkbox 'Wizard mode' to get more detailed help.
Note: The same device is used for all GWs.
For testing and commissioning purposes it is a good idea to have either a laptop with
the server software installed which you can use to directly connect to gateways as
they are installed, or a laptop with a connection to the live application server. This
will allow you to test radio signal strength as you are installing the devices on each
floor so issues can be addressed immediately.
Note: The network information is stored in the GWs and not in the laptop.
3.1.1 TL Concentrator
TL Concentrator is a utility for simplifying the setup of a firewall when the GWs are
located on a different network. TLConcentrator runs on the ZigBee server and listens
for GWs on one port and forwards all traffic to the application server on another port.
All traffic from the application server is sent to the correct GW. In this way, the
firewall will only have to be set up to allow sockets from the ZigBee server.
The alternative would be to set up the firewall to allow sockets for every GW.
This would add implications, especially when adding or exchanging GWs.