User's Manual

30
ASSA ABLOY Hospitality
66 3081 004-23
Menu choice
Description
Form new network
makes a total reset of the GW
Set channels
selects allowed channels; see section 9.1
Communication channel for further information
Set PAN ID
sets another identity
Note: The Set PAN ID choice is normally not used,
since the PAN ID is given automatically by the
network. If the PAN ID is 0x000, choose Form
new network in the right-click menu for the GW;
see above.
Reset
makes a reset; all data is retained
Get
User Description
gets parameters (e.g. version) for the node
Get IEEE address
and children
gets the IEEE address as well as all children stored
in the association list
Permit Joining
makes it possible for children to join
Forbid Joining
forbids children to join
Add Node
This menu choice can be used e.g. if a gateway in
a corridor is broken and needs to be replaced. The
children under the gateway must then be set up as
new nodes in the association table, and instead of
needing to go into the guest rooms to fix this it can
be done from the Add Node dialog; see details here.
Edit Name
edits the node's name in the database
Memory Dump
reads the memory; only used by Technical support
Remove
removes the GW from the database
Upgrade Firmware in
PAN Coordinator
loads a new firmware into the PAN coordinator; see
bootload dialog in Figure 33
Note: The firmware shown is the one that has been
loaded into the application server database at
Tools/Module firmware; see the client setup
manual for details.
Upgrade Firmware in
Gateway
see bootload dialog in Figure 33
Note: This menu alternative is not applicable for
the older type of gateway (9VDC).
Dump Gateway Log
creates an xls file with internal gateway events for
troubleshooting purposes
Table 1