User's Manual
Table Of Contents
- FCC and ISED (IC) statements
- 1. Introduction
- 2. Installing the option
- 3. Installing online devices
- 4. Online settings in the client
- 5. Issuing a ZigBee configuration card
- 6. System operation
- 7. Commissioning
- 8. Power loss and hardware failure
- 9. Redundancy and recovery
- Appendix A: Online devices
- Appendix B: Mounting of gateway and router
- Appendix C: Example configurations
- Appendix D: Web interface for gateway
- Appendix E: Reset of gateway
- Appendix F: Gateway boot-up
- Appendix G: More about how the gateway finds the server
- Appendix H: Firmware upgrade
34
ASSA ABLOY Hospitality
66 3081 004-23
4. Online settings in the client
This section describes
door parameters for online doors
online authorities for operator templates
the function prevent invalid staff card usage; this function is only applicable for
hotel systems
For setup of doors (online as well as non-online doors), see the section about doors in
the setup manual for the client.
4.1 Setting up door parameters in a hotel system
Go to Tools/Options in the client and click Online in the left column; you can make
settings regarding
1. Door ajar alarm
2. Status - intruder and offline status
3. Miscellaneous
4. Alarms
5. Safes
4.1.1 Door ajar alarm
Figure 39
You can modify the time for when there will be a door ajar alarm. The door ajar
alarm can be 1-60 minutes; 0 means that the alarm is not used. The default
values are:
2 minutes when a guest card type has opened the door
2 minutes when a door has been opened from the inside
30 minutes when a staff card type has opened the door