User's Manual
Table Of Contents
- FCC and ISED (IC) statements
- 1. Introduction
- 2. Installing the option
- 3. Installing online devices
- 4. Online settings in the client
- 5. Issuing a ZigBee configuration card
- 6. System operation
- 7. Commissioning
- 8. Power loss and hardware failure
- 9. Redundancy and recovery
- Appendix A: Online devices
- Appendix B: Mounting of gateway and router
- Appendix C: Example configurations
- Appendix D: Web interface for gateway
- Appendix E: Reset of gateway
- Appendix F: Gateway boot-up
- Appendix G: More about how the gateway finds the server
- Appendix H: Firmware upgrade
38
ASSA ABLOY Hospitality
66 3081 004-23
'The maximum number of minutes a staff person may be inside an unsold room
with the door closed before an alarm is triggered'; default is 30 minutes. This
parameter is related to the alarm Invalid staff-card usage; see the user manual
for the client for more information.
'The maximum number of guest cards that may be issued from the client before
an alarm is triggered.' This parameter is related to the alarm Too many guest
cards issued in the client; see 'To limit the guest card issuing' in the setup
manual for the client for more information.
'The maximum number of times a card may be used per X minutes before an
alarm is triggered.' This parameter is related to the alarm Excessive card usage.
'The above X minutes'. This parameter is related to the alarm Excessive card
usage.
'The maximum percentage of reading errors before an alarm is raised for the
reader.' This parameter is related to the alarm Bad card reader.
Note: The alarm Bad card reader is triggered if the percentage of reading
failures exceeds the percentage that is entered in this field. The alarm must be
completed manually. The percentage is calculated continuously and there is no
lower limit for the number of reads needed for the calculation.
The maximum number of minutes a router may be offline before an alarm is
triggered. This parameter is related to the alarm ZigBee Router Offline.
The maximum number of minutes a gateway may be offline before an alarm is
triggered. This parameter is related to the alarm ZigBee Gateway Offline.
The maximum number of minutes a door may be without activity before an
alarm is triggered. This parameter is related to the alarm No door activity.
4.1.5 Safes
Safes can be set up at Tools/Options/Online/Safes and also require the In-room
safes option; see Installation instruction In-room safes option for details.
4.2 Setting up door parameters in an access control system
Go to Tools/Options in the client and click Online in the left column; you can make
settings regarding
1. Status - intruder and offline status; see section 4.1.2 for details
2. Miscellaneous; see section 4.1.3 for details
3. Alarms; see section 4.1.4 for details