User's Manual
Table Of Contents
- FCC and ISED (IC) statements
- 1. Introduction
- 2. Installing the option
- 3. Installing online devices
- 4. Online settings in the client
- 5. Issuing a ZigBee configuration card
- 6. System operation
- 7. Commissioning
- 8. Power loss and hardware failure
- 9. Redundancy and recovery
- Appendix A: Online devices
- Appendix B: Mounting of gateway and router
- Appendix C: Example configurations
- Appendix D: Web interface for gateway
- Appendix E: Reset of gateway
- Appendix F: Gateway boot-up
- Appendix G: More about how the gateway finds the server
- Appendix H: Firmware upgrade
45
ASSA ABLOY Hospitality
66 3081 004-23
alarms occur. From the user notification list, it is also possible to set up that reports
should be sent via e-mail. The reports can either be alarm reports, or reports about
items that do not trigger alarms; e.g. a summary of issued cards.
See Installation instruction Communication option for more information about the
user notification list and other features of the Communication option.
6.2.3 Endnode list
The endnode list in the software shows ZigBee endnodes in the system with IEEE
address, firmware version and door name.
Note: Endnodes in thermostats are not shown in the list.
To remove an endnode from the endnode list:
1. Double click on Endnodes under the Lists tab in the navigation window.
Figure 47
2. Mark the endnode in the list and click Remove. The endnode will
automatically also be removed from the treeview in SysMon.
Note: If a * is shown in the dialog caption, one or more endnodes have been added,
removed or renamed. In this case, press the Refresh button in the endnode list.