User's Manual

61
ASSA ABLOY Hospitality
66 3081 004-23
Appendix D: Web interface for gateway
The gateway parameters can be modified to suit the network where the gateway is
located. This is done via the web interface as described below.
Note: See Table E1 in Appendix E for a description of the gateway parameters.
To modify the gateway parameters:
Figure D1
1. Press the F button on the gateway for a
short while; the status LED on top of the
gateway will blink yellow. See in Appendix
A where the F button is located.
2. In the web browser, enter http://
ipaddress; the IP address to enter is shown
when hovering over the gateway in
SysMon. See example below for IP address
entered in the web browser:
Figure D2
Note: If no DHCP server is available, use
the zero config IP address which is shown
in Wireshark; see section 1.3.1 for more
information about zero config.
3. Make the desired changes in the ZigBee
Gateway Setup page; see example in
Figure D1.
4. If the server IP should be changed and
there is no DNS (Domain Name System):
- Enter the applicable Server IP
OR
- Mark the radio button 'Enable' for
Announcement Broadcast; this makes
the gateway find the server.
5. When all desired changes have been done
in the ZigBee Gateway Setup page:
- Click Save.
- Click Reboot.
- Press the F button on the
gateway again.