User's Manual
Table Of Contents
- FCC and ISED (IC) statements
- 1. Introduction
- 2. Installing the option
- 3. Installing online devices
- 4. Online settings in the client
- 5. Issuing a ZigBee configuration card
- 6. System operation
- 7. Commissioning
- 8. Power loss and hardware failure
- 9. Redundancy and recovery
- Appendix A: Online devices
- Appendix B: Mounting of gateway and router
- Appendix C: Example configurations
- Appendix D: Web interface for gateway
- Appendix E: Reset of gateway
- Appendix F: Gateway boot-up
- Appendix G: More about how the gateway finds the server
- Appendix H: Firmware upgrade
8
ASSA ABLOY Hospitality
66 3081 004-23
End product labeling
The endnode module is labeled with its own IC Certification Number. If the IC Certification Number is not
visible when a module is installed inside another device, then the outside of the device into which the module
is installed must also display a label referring to the enclosed module. In that case, the final end product
must be labeled in a visible area with the following:
'Contains IC: 8231A-EN110'
'Contains IC: 8231A-EN055'
The OEM of the respective module must only use the approved antenna listed above, which have been
certified with this module. The OEM integrator has to be aware not to provide information to the end user
regarding how to install or remove this RF module or change RF related parameters in the user’s manual
of the end products.