User's Manual
2 66 1402 203-5
66 1402 203-1
Introduction
With the Mobile Access option set in the Visionline software, the BLE technology (Bluetooth
®
Low Energy) is used for exchanging data. Instead of using
cards for access, mobile keys are used. The guest must have a Bluetooth
®
telephone which is registered with an Endpoint ID, and an app for opening the door.
A 3G RFID Signature lock is upgraded to BLE usage by following the steps in this instruction.
Parts for the upgrade
Pos
Description
Quantity
1
Y-cable ZigBee&BLE for Classic
1
2
Housing BLE
1
3
Shield BLE
1
4
Screw standoff
2
5
Cable sleeve
1
Tools for the upgrade
Screwdriver Torx TR20
Lock Service 3G; minimum version 1.1.1
USB interface 3G; complete ordering name
is cable RJ12 to USB adapter (for 3G)
Service cable; complete ordering name
is service cable RJ12 for 3G RFID LCU
& E-cylinder
Figure 1: Signature kit, housing BLE
Figure 2: BLE module
Table 1: Contents of ’Signature kit, housing BLE’
The information in this document is subject to change at the sole discretion of ASSA ABLOY without notice. Any use, operation or repair in contravention of this document is at your own risk. ASSA ABLOY does not assume any responsibility
for incidental or consequential damages arising from the use of this document. All information and drawings in this document are the property of ASSA ABLOY. Unauthorized use and reproduction is prohibited. VingCard and Elsafe are registered
trademarks of ASSA ABLOY. For R&TTE statements for the BLE module, see ‘Installation instruction Mobile access option’.