User's Manual

90
DRAFT 66 8003 002-11
To add the lock to the in-room network
The in-room network is configured under the Configure device section in
Orion Service.
Configuration
Description
Form new
network
This configuration removes all nodes in the PAN and resets
the coordinator.
Permit join When this c onfigurat ion is used, an in- room device (RF door
switch, motion sensor or lock) can join the coordinator.
Forbid join When the RF door switch, motion sensor or lock has joined the
coordinator, this configuration should be used on the c oordinator.
Note:
If the Forbid join command is for some reason forgotten,
it will aut omat ic ally be exec ut ed 15 minut es after the Permit
join command was executed.
Set channels Default is that all channels are ON (the '1' indicates ON);
the best c hannel will automat ically be c hosen, so normally
the Set channels command is not needed.
Get network This configuration shows the in- room network.
Note:
When hovering with the cursor over an item in the network,
the tooltip will show what type of item it is; e.g. 'Coordinator' as
in the screenshot example above. The tooltip will also show e.g.
IEEE address and firmware version.