User's Manual

91
DRAFT 66 8003 002-11
Scenario with wired thermostat
1. Go t o Start/Programs/
Orion Service/Orion Service.
2. Choose Configure device
intheleftpaneofthe
Orion Service window.
3. Plug the service cable into
the thermostat.
4. Choose the Coordinator tab.
5. Clic k Form new network.
Figure D3
6. Clic k t he Get network button;
the thermostat will appear in the
window below Get network.
Figure D4
7. Put the cursor on the thermostat
in t he Orion Servic e window; an
informat ion box, showing e.g. the
thermostat channel, will appear.
If the channel should be changed,
c lick the applic able c hannel (in the
picture example '26') and c lick the
Set channels button.
8. Mark t he thermost at and c lick
the Permit join button.
Figure D5
9. Right click on the thermostat and
choose Get user description.
Information about the thermostat
will be shown; see picture to the
right. Make sure that
- the c hannel is correct
- it says 'yes'at 'Join permitted'
Note:
If it does not say 'yes' at
'Join permitted', click the Permit
join button again.
Figure D6