User's Manual
Table Of Contents
- Table of contents
- FCC and IC statements
- 1. Introduction
- 1.1 Orion EMS devices
- 1.2 Terminology
- 1.3 General about Orion Service
- 1.4 General about alarms
- 1.5 Events and commands
- 1.6 Basic EMS logic
- 1.7 Orion EMS parameters
- 1.8 Operator templates
- 1.9 Setback override
- 2. Thermostat buttons and display
- 3. Energy management summary and alarm list
- 4. Real time room status
- 5. Thermostats list
- 6. Occupancy report
- 7. Energy statistics report
- 8. Tools/Options
- 9. Orion EMS in SysMon
- 10. Maintenance
- Appendix A: Quick reference of technical data
- Appendix B: Troubleshooting
- Appendix C: Read more
- Revision history
23
DRAFT 66 8003 001-8
1.8 Operator templates
The operator templates decide the level of authority for different Orion EMS operations.
To change the authority for handling thermostat parameters:
1. Double click on Operator
templates under the Lists
tab in the navigation window.
2. In the Operator templates
dialog, mark the applicable
operator template and click
Properties; or click Add if a
new operator template should
be added.
3. In the Operator template
details dialog, choose the tab
Energy management in the
left part of the dialog. Make
the desired changes regarding
- overriding setback mode
- setting the room temperature
- changing advanced parameters
- changing basic parameters
Note: By default, all four items
above are marked for system
manager but unmarked for
other operator templates.
4. If a new operator template was
added, go through the other
tabs in the left part of the
Operator template details
dialog and fill in the applicable
information; see Setup manual
VISIONLINE for detailed
information.
5. Click Update (or Save if a new
operator template was added)
and Close.
Figure 6