User's Manual

27
DRAFT 66 8003 002-11
3.3.1 Step-by-step procedure (Orion Thermostat-Original-LV)
For a new thermostat, the following steps must be followed:
1. Make sure that the thermostat has
got the latest available firmware:
- Plug t he servic e c able (see
Figure 29) into the thermostat.
-InOrion Servic e (see Figure 30):
choose the Versions alternative
and c lic k the Re a dout button.
See Quic k referenc e guide Orion
Service for more information
about the software.
2. Mount the thermostat according
to here
.
3. Add the thermostat to the
Thermostats list in VISIONLINE;
in t he Thermostat details dialog
you should also choose the profile
to which the thermostat should
belong. If no applic able thermostat
profile exists in VISIONLINE, c reat e
one according to here
.
4. Initialize t he t hermostat with room
number and also with parameters
according to the chosen
thermostat profile; follow the
Initialize section in Quick reference
guide Orion Servic e. Note:
If one
or more parameters of a thermostat
profile are at a later oc c asion
updated, these new parameters
will automatic ally be sent to all
concerned online thermostats.
If the thermostats are not online,
they are updated via the Initialize
alternative in Orion Servic e.
5. Make external connec tions
according to here
.
6. If the thermostat should be online,
setitupintheonlinenetwork
according to Quic k setup guide
Orion EMS in VISIONLINE.
Figure 29: Service cable RJ12 to 3.5mm stereo jack
(Art. No 205 999 008)
Figure 30