User Manual

Copyright © 2011, ASSA ABLOY All rights reserved. Reproduction in whole
or in part without the express written permission of ASSA ABLOY is prohibited.
WFMN5A • PAGE 2
CHAPTER 1: TECHNICAL SPECIFICATIONS ...............................................................................................................................3
CHAPTER 2: SYSTEM OVERVIEW .................................................................................................................................................3
Introduction .............................................................................................................................................................................3
System Description ..................................................................................................................................................3
The Aperio Programming Application ..................................................................................................................3
CHAPTER 3: INSTALL THE COMMUNICATION HUB ..............................................................................................................4
Instructions ..............................................................................................................................................................................4
AH20 Integration(Wiegand) ..............................................................................................................................................5
AH20 DIP Switch Configuration ............................................................................................................................5
AH20 DIP Switch Configuration Table ..................................................................................................................6
Connections for AH20 (J100) .................................................................................................................................6
Connections for AH20 (J103) .................................................................................................................................7
Tamper Switch (AH20) ............................................................................................................................................7
AH13/AH30 Integration (RS485) ......................................................................................................................................7
AH13/AH30 DIP Switch Configuration .................................................................................................................8
AH13/AH30 DIP Switch Configuration Table .......................................................................................................8
Connections for AH13/AH30 ..................................................................................................................................9
Select EAC Address ................................................................................................................................................................9
RS485 Bus Connection ......................................................................................................................................................10
Physical Hub Installation ..................................................................................................................................................11
Communication Hub Adapter Plate Insatllation ............................................................................................. 11
Hub LED Indication .............................................................................................................................................................12
Table of Contents
FCC Statement:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful Interference to radio or television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is Connected.
• Consult the dealer or an experienced radio/TV technician for help.”
Industry Canada:
This Class B digital apparatus meets all requirements of the Canadian Interference Causing Equipment Regulations.
Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may cause undesired operation.
Cet appareillage numérique de la classe B répond à toutes les exigences de l’interférence canadienne causant
des règlements d’équipement. L’opération est sujette aux deux conditions suivantes: (1) ce dispositif peut ne
pas causer l’interférence nocive, et (2) ce dispositif doit accepter n’importe quelle interférence reçue, y compris
l’interférence qui peut causer l’opération peu désirée.
Warnings:
Changes or modifications to this device not expressly approved by ASSA ABLOY could void the user’s authority to
operate the equipment.
“This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This
equipment should be installed and operated with minimum distance 20cm between the radiator and your body.
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.”
Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type and
maximum (or lesser) gain approved for the transmitter by Industry Canada. To reduce potential radio interference
to other users, the antenna type and its gain should be so chosen that the equivalent isotropically radiated power
(e.i.r.p.) is not more than that necessary for successful communication.