User Manual

Table Of Contents

Users in the USA and Canada English:

Operation is subject to the following two conditions:

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1) this device may not cause harmful interference, and (2) this device must accept any interference

received, including interference that may cause undesired operation.

RF Exposure

For Mobile Devices include the following:

“This equipment complies with FCC radiation exposure limits set forth for an uncontrolled envi

ronment. This equipment should be installed and operated with minimum distance 20cm be-

tween the radiator and your body. This transmitter must not be co-located or operating in con-

junction with any other antenna or transmitter.”

Pour les usagers résidant au Canada (French):

L’exploitation est autorisée aux deux conditions suivantes:

(1) l’appareil ne doit pas produire de brouillage, et (2) l’utilisateur de l’appareil doit accepter tout brouillage

radioélectrique subi, même si le brouillage est susceptible d’en compromettre le fonctionnement.

Énoncé d’exposition à la radiation

Pour les appareils mobiles sont les suivants:

“Cet équipement est conforme aux limites d’exposition à la radiation RF

FCC prévues pour un environnement non contrôlé. Cet équipement doit être

installé et doit fonctionner avec une distance minimum de 20 centimètres des

utilisateurs et des personnes Environnantes. Cet émetteur ne doit pas être co-

localisées ou opérant en conjointement avec une autre antenne ou émetteur

Assembly Drawings and Instrucons:

53-5378TAB

52-5376RTAB

52-4890

Factory Conguraon Instrucons:

The assembly 52-9051-0000-000 IN120 BT shall be programmed at the manufacturing facility with

rmware. The rmware version to be programmed into the unit shall be V5.09, which applies an

adversing rate of 20ms and a RSSI tap sensivity of -55dB.

Field Conguraon Instrucons:

At the customer site, encrypon keys are loaded by a “Mobile Keys” cered technician using an HID

conguraon card. This installaon can be performed on mobile enabled readers only. Once the “Mo

bile Keys” have been loaded interface with mobile devices can be achieved.

The HID BLE Conguraon applicaon is currently available on Android OS and provides addional

conguraon that can be used to congure tap sensivity and transmission power. Transmission power

is restricted to a maximum of 0dBm. The HID BLE Conguraon applicaon can be used to upgrade

the BLE devices rmware using the OTA technology. Field rmware upgrades can only be performed

through and HID cered technician that are authorized to use a controlled administraon card.

or in part without the express written permission of ASSA ABLOY Inc. is prohibited.

BTMN1A • PAGE 2

09/15