User Manual
Table Of Contents
12/15/10
1-800-810-WIRE • www.sargentlock.com • A8032D 15
Copyright © 2010, Sargent Manufacturing Company, an ASSA ABLOY Group company. All rights reserved.
Reproductions in whole or in part without express written permission of Sargent Manufacturing Company is prohibited.
Passport 1000 Series P1 PoE Mortise Lock
7
Install Gasket (Optional)
Note: Optional, for non-fire rated doors only.
For non-fire rated door applications, an optional gasket may be
used as a weather seal between the escutcheon and the outside
door surface.
Peel off adhesive backing and attach to outside escutcheon.
Fig. 7A
Outside
Passport
Trim
Gasket
8
Install Outside Escutcheon and Mounting Plate Assembly
1. Insert the mounting posts through holes as shown.
2. On the inside of the door, position the mounting plate
over the indicated holes.
3. Feed PoE and reader cables through side opening (Fig. 8A).
Cable from lockbody feeds from bottom (Fig. 8A and 8B).
4. Attach 2 ground ring terminals, one from controller and
one from lock body to bottom right corner using one
#8-32 x 1-7/8” flat head machine screw.
Make sure they are positioned upright (Fig. 8A).
5. Insert other three #8-32 x 1-7/8” flat head machine
screws and tighten, fastening the outside escutcheon
to the door (Fig. 8B).
IMPORTANT: If the following step is skipped,
the product will not be UL-compliant:
6. Attach two (2) #8 x 3/8” flat head wood screws for
wood doors or (2) #8-32 x 3/8” flat head machine
screws for metal doors (Fig. 8C).
(4) #8 - 32 x 1-7/8”
Flat Head
Machine Screws
Mounting Plate
Fig. 8B
Attach ground wires to
bottom right screw
a
Outside
Passport
Trim
PoE Reader Cables
Fig. 8C
(2) #8 - 3/8”
Flat Head
Wood Screws OR
(2) #8 - 3/8”
Flat Head
Machine Screws
e
d
c
b
(2) 4-Pin PoE
connectors
e
d
b
c
24-pin from reader
10-pin from lock body
a
Ground wires and PoE and
Lock body harnesses
Reader cable (iCLASS only)
f
Reader cable (iCLASS only)
f
Reader cable (iCLASS
only)
Controller /
Reader
Cables
Lockbody Cables
Lock Ground
Position
ground ring
terminal
upright,
then
tighten
screw.
Reader cable
(iCLASS only)
PRELIMINARY