User Manual

16 1-800-810-WIRE • www.sargentlock.com • A8032D
Copyright © 2010, Sargent Manufacturing Company, an ASSA ABLOY Group company. All rights reserved. Reproductions in whole or in part without express written permission of Sargent Manufacturing Company is prohibited.
12/15/10
Passport 1000 Series P1 PoE Mortise Lock
9 Install Inside Module Component Assembly
Insert bottom of Module Component Assembly first (Fig.
9A), then clip top of Assembly to backplate, verifying
both tabs attached securely.
Outside of Door
Fig. 9A
Tabs
Detail 10B
(2) 4-Pin PoE
connectors
e
d
b
c
24-pin from reader
10-pin from lock body
e
d
c
b
10 Attach Connectors
Secure the following connectors onto the circuit board (Fig.
10A and 10B):
1. Secure the 10-pin lock body assembly connector (e).
2. Secure the 24-pin keypad/card reader connector (d).
3. Secure two 4-pin PoE connectors (b and c).
4. Secure the iCLASS reader cable (f).
Route wires from behind backplate through battery com-
partment.
Notes:
• Connectors go on only one way.
• Do not force and do not offset connectors.
• Be sure the connectors are completely seated (flush).
f
9-pin reader cable (iCLASS only)
f
PRELIMINARY