User's Manual

07/31/16
1-800-810-WIRE • www.sargentlock.com • A8189B 15
Copyright © 2016, Sargent Manufacturing Company, an ASSA ABLOY Group company. All rights reserved. Reproductions in whole or in part without express written permission of Sargent Manufacturing Company is prohibited.
IN100 Cylindrical Lock
Fig.
10B
*Gasket is required for outdoor installations. Do not use gasket for fire-rated openings.
If installing with gasket; separate gasket from mounting plate to feed cables/connectors
through holes as indicated (Fig. 10B).
Once cables/connectors are fed through, reattach gasket to mounting plate.
Lockbody
Harness
Ground Ring
Terminal
Through-bolt
NOTE: Cable lengths exaggerated for illustrative purposes
Gasket*
Mounting
Plate
Door Position
Switch
Through-bolt
Reader Harness
10 Outside Reader Installation (Continued)
Fig. 10C
6. Secure ground lug with #6-32 machine screw (Fig. 10C).
4. Feed the reader harness and DPS connectors through the inside mounting assembly
(and gasket if required*). See Figure 11B.
IMPORTANT: Do not run wires through bottom flange hole in plate (Fig. 11B, C) - it will damage wires and
the controller connector. Route wires around flange, do not route wires through the flange hole (Fig. 11C).
5. Tuck excess cable into wire hole on inside of door.
6. Begin to secure the mounting assembly by partially tightening the (2) through-bolts on the
inside of the door while ensuring proper alignment as you secure the reader (Fig. 11B).