User's Manual

IN100 Mortise Lock
16
Copyright © 2016 Corbin Russwin, Inc., an ASSA ABLOY Group company.
All rights reserved. Reproduction in whole or in part without the
express written permission of Corbin Russwin, Inc. is prohibited.
5) Installation Instructions (Continued)
Fig. 14b
Ground Ring
Terminal
Lock Body
Harness
Through-bolt
Reader
Harness
Through-bolt
Inside
Mounting Plate
Gasket*
Door Position
Switch
*Gasket is required for outdoor installations. Do not use gasket for fire-rated openings.
If installing with gasket; separate gasket from mounting plate to feed cables/connectors through holes as
indicated (Fig. 14c).
Once cables/connectors are fed through, reattach gasket to mounting plate.
NOTE: Cable lengths exaggerated for illustrative purposes.
Inside Face of Door
Inside Face
of Door
Fig. 14c
g. Secure ground lug with #6-32 machine screw (Fig.10C).
d. Feed the reader harness and DPS connectors through the inside mounting assembly
(and gasket if required*). See Figure 11B.
IMPORTANT: Do not run wires through bottom flange hole in plate (Fig. 11B, C) - it will damage wires and
the controller connector. Route wires around flange, do not route wires through the flange hole (Fig. 11C).
e. Tuck excess cable into wire hole on inside of door.
f. Begin to secure the mounting assembly by partially tightening the (2) through-bolts on the
inside of the door while ensuring proper alignment as you secure the reader (Fig. 11B).