User Manual

ManualsBrandsASSA ABLOY ManualsElectronicsMicroprocessor Controlled Networked Locks

Table Of Contents

01/29/11

1-800-810-WIRE • www.sargentlock.com • A7764B 13

Reproductions in whole or in part without express written permission of Sargent Manufacturing Company is prohibited.

Profile Series v.S1 PoE Mortise Lock

Step #6 – Install Outside Escutcheon and Lever Assembly

1A. For ﬁre rated doors, feed ribbon cable with connector and ground wire from

outside of door through weatherseal gasket and ﬁre stop plate (Fig. 6A).

Note: Install ribbon cable with cable exiting down

1B. For non-ﬁre rated doors, feed ribbon cable with connector and ground

wire from outside of door through weatherseal gasket (if used)

and weather conduit (Fig. 6A).

Note: Install ribbon cable with cable exiting down

2. With outside lever horizontal, locate the outside escutcheon on the door,

while directing the mounting posts through the door and lock body (Fig. 6B).

Make sure the lever spindle is properly engaged in lock.

3. On the inside of the door, insert spindle into square hole

of mortise lock.

4. Slide inside adapter and plate

assembly over spindle and loosely

secure with 2 through bolt

screws (#8-32 x 5/8”).

Note: For 8276 and 8278,

loosely thread cylinder

through escutcheon

and into the lock body

before tightening the

lock case screws

and escutcheon

through bolts.

Gasket 82-0500

Step #5 – Install Gasket (for Exterior Doors)

1. Carefully remove the backing from the gasket.

2. Apply gasket to escutcheon:

• Starting in one place, press the adhesive side

of the gasket ﬁrmly against the escutcheon.

• Work around the escutcheon, pressing the sticky side

of the gasket ﬁrmly against the escutcheon edge.

• The gasket should be aligned so that all edges

of the escutcheon are covered.

3. Attach escutcheon to the door after the wires

are connected.

Note: The 43 cylinder may be used with or without a gasket.

Fig. 5A

Inside of Door

Mortise Lock body

and AX Connectors

Fig. 6B

Reader

Cable

Ground

Wire (E1)

Antenna

(iCLASS)

JST 4-Pin

From Hinge

Ground

Ring Terminal

Antenna

(iCLASS

only)

Fig. 6A

Outside of Door

Keypad

Ribbon

Cable

Ground

Wire (E1)

Keypad

Ribbon

Cable

Ground

Wire

(E1)

Gasket

Antenna

(iCLASS)

Only

Fig. 5B