User Manual
Table Of Contents
6 1-800-810-WIRE • www.sargentlock.com • A7764B
Copyright © 2011, Sargent Manufacturing Company, an ASSA ABLOY Group company. All rights reserved.
Reproductions in whole or in part without express written permission of Sargent Manufacturing Company is prohibited.
01/29/11
Profile Series v.S1 PoE Mortise Lock
Door Harness Installation
Order of installation may vary.
Refer to appropriate sections for instructions.
1. Prop door open.
2. Tape the two lock-side 4-pin connectors to the ring terminal.
3. Using the ring terminal, carefully fish the assembly through the
door channel to the lock.
4. Remove tape from ring terminal and door harness connectors.
Hinge-side harness connectors:
• 4-pin male Molex connector
• 6-pin male Molex connector with ground wire
Lock-side harness connectors:
• Ring terminal
• (2) 4-pin connectors:
• 4-pin Molex connector
• 4-pin connector
C
Ground
4-Pin
Molex
JST
4-Pin
6-pin M
Cable: CAT 5e,
26 AWG stranded,
shielded, 100ohm
Ring Terminal Secured
to Lock Mounting Plate
PoE Lock
C
4-pin F
Drain Wire
D
JST 4-Pin
From Hinge
Connectors
From Lock body
Ground
Ring Terminal
Inside of Door