DR10 Drag Race Car RTR Instruction Manual

2
:: Introduction
:: KIT Features
:: Additional
Thank you for purchasing this Team Associated product. This assembly manual contains instructions and tips for building and
maintaining your new RTR. Please take a moment to read through this manual to help familiarize yourself with these steps.
We are continually changing and improving our designs; therefore, actual parts may appear slightly different than in the
illustrations. New parts will be noted on supplementary sheets.
Tools included:
• Allen wrenches 1.5mm, 2.0mm
• #1113 12mm Shock Tool
Associated Electrics, Inc.
21062 Bake Parkway.
Lake Forest, CA 92630
http://www.RC10.com · http://twitter.com/Team_Associated · http://www.instagram.com/teamassociatedrc/ · http://www.facebok.com/TeamAssociated/
Customer Service
Tel: [phone]
Fax: [phone]
:: Other Helpful Items
• Based on the 9-time R.O.A.R. National Champion short-course race truck platform
• 2.4GHz 2-channel radio with new DVC (Dynamic Vehicle Control) receiver featuring built-in adjustable gyro
• High-torque, metal-gear Reedy Servo with spring style servo saver
• Powerful Reedy 3300kV brushless motor
• Water-resistant high-power Reedy brushless speed control with T-plug connector and LiPo low voltage cutoff
• Water-resistant enclosed receiver box
• Factory-finished two-piece Reakt drag race body with rear spoiler
• Three position wheelie bar with optional large wheels
• Lightweight drag race inspired wheels
• Lightweight front drag tires
• High grip rear drag slick tires
• Durable and lightweight aluminum top shaft
• Low center-of-gravity molded composite chassis with hook-and-loop battery straps fit both NiMH and 2/3s LiPo battery packs
• Metric hardware throughout
• 18 precision rubber-sealed ball bearings
• Durable front and rear wide body mounts
• Rear CVA drive shafts for more reliability
• Aluminum 12mm big bore coil-over shock absorbers
• 2.6:1 ratio gearbox with heavy-duty sealed gear differential and externally adjustable V2 slipper clutch
• Rugged steel turnbuckles for adjustable camber and front toe-in
• Adjustable suspension geometry
• Vertical ball ends for roll center adjustments, front and rear
Your new RTR comes factory assembled including radio gear, motor, and
ESC. However, there are some items you will need to complete your kit
(refer to catalog section for suggestions):
• AA-size batteries for transmitter (#302 x4)
• Peak Detection Charger or LiPo Compatible Charger
• 6 cell NiMH battery pack or 2/3S LiPo battery pack w/High Current T Plug.
• Green Slime shock lube (AE # 1105) • Cyanoacrylate glue (AE # 1597)
• Thread Locking Compound (AE # 1596) • Silicone Shock Fluid (Refer to catalog for complete listings)
• Silicone Diff Fluid (Refer to catalog for complete listings) • Body Scissors (AE # 1737)
• 8 Piece Hex Driver Set (AE # 1655) • FT Hex Wrenches (AE # 1655)
• Hobby Knife • Needle Nose Pliers • Wire Cutters • Soldering Iron
• Calipers or a Precision Ruler • Reamer / Hole Punch • Ride Height Gauge (AE #1449)
• FT Nut Drivers (AE #1663 - 1668, used with #1655 or 1656 handle) • Turnbuckle Wrench (AE #1114)