G660 User’s Manual
CONTENTS 1. Before Use Cautions upon Use Package Components Names of Product Components Installing the Power Installing in the Vehicle 2. Basic Product Functions Using the Memory Card Firmware Update Key Product Features How to Operate the Product Voice Guidance on Product States and LED Display Checking through the Micro SD Card 3. PC Viewer Features Installing the PC Viewer PC Viewer Features 4.
Chapter 01┃ Before Use Cautions upon Use Information Contents intended to prevent potential dangers by notifying consumers on the level of damage (bodily, monetary) of product safety matters (electric shock, fire, explosion) in cases of consumer misuse. Read the following contents carefully for proper use. Safety Warnings – Failure to observe the safety instructions within this category could result in serious injury or death.
Cautions upon Use Chapter 01┃ Before Use Product related Never clean the product with chemical materials, such as benzene or thinners. Such materials may damage the device surface or cause internal malfunctions. Do not subject the product to severe shock or introduce foreign objects. Please heed caution as the introduction of foreign substances could lead to product malfunction. 01 Before Use 02 Always maintain the front side of the product in a clean state.
Cautions on Safety and upon Use Chapter 01┃ Before Use Driving related Refrain from prolonged use with the ignition turned off. Such acts could lead to battery discharge. Do not watch or operate the product while driving. Operating the product while driving may result in accidents. Refrain from excessive front window tints. Heed caution as videos recorded within vehicles with sun tints may be somewhat blurry or distorted.
Cautions on Safety and upon Use Chapter 01┃ Before Use GPS Related Semi-commercial GPS products possess a margin of error of approximately 15m. Buildings, underground roads, tunnels, and roadside trees could increase the margin of error or prevent the GPS from being properly received. The time required to receive the GPS signal from the point of turning on the device could be more than 10 minutes depending on the weather or environmental conditions.
Chapter 01┃ Before Use Package Components Basic Components Power Cable A/V Cable Installation CD GPS Receiver Cable Organizer Micro SD Card User’s Manual Extra Adhesive Tape USB Cable 01 Before Use Camera • Check to see that all of the product components, shown above, are included. • In case of missing components, please contact your place of purchase. • The contents of this user’s manual are subject to change without prior notice for product improvement.
Chapter 01┃ Before Use Names of Product Components Names of Product Components 12 Mount (external GPS included) 11 6 DC Power Input Terminal Video Input port 01 Before Use 10 4 Camera Lens 2 USB Port 1 VIDEO Output port 10) GPS Input terminal 7 Micro SD Slot 06 6 Record Button 3 Speaker 4 Cancel Button 6 LED ※ The outer appearance may differ with the actual product and is subject to change without prior notice for performance and quality improvements.
Chapter 01┃ Before Use Names of Product Components Descriptions of Product Components Name Description 1) VIDEO output port Displays live video of recorded scenes . 2) USB Port When connected with a PC, plays recorded videos and used to copy files to storage devices. 3) Speaker Outputs product operating states through voice guidance. 4) Camera Lens Films the front of the vehicle. (Heed caution so that foreign substances do not cover the front of the lens.
Chapter 01┃ Before Use Installing in the Vehicle Caution upon Installation • Please refrain from repeated detaching/re-attaching once the product has been installed. • Do not install or use the device outside of the vehicle. Attach the device in a place where the driver’s field of vision is not blocked.
Chapter 01┃ Before Use Installing in the Vehicle Connecting the camera to the vehicle Connect the Main Unit and the Mount Connect Cigarette Jack (Main Unit) Insert the Memory Card Organize Power Cable, Connect Power Place the groove at the top side of the main unit against the groove area on the mount and push until a “click” sound is heard. Remove Double-sided Tape Remove the double-sided tape attached to the mount.
Chapter 02┃ Basic Product Functions Installing in the Vehicle Inserting the Memory Card 02 Basic Product Functions • Insert the memory card with the part where the cut edge facing up. (refer to the product image above) • Fully insert the card into the card slot. • After inserting, connect the power plug and check whether the memory card is properly inserted through the voice guidance.
Chapter 02┃ Basic Product Functions Using the Memory Card Recording Times by Memory Capacity The recording times shown below are the maximum values calculated for each recording mode and may slightly differ upon actual use. Infinite Mode Memory Classification Size Infinite Recording Event Recording Parking Mode Manual (Forced) Event Recording Reference Parking Recording Event/ Motion Recording 32 minutes 7 minutes 5 minutes 36 minutes 23 minutes Max No.
Chapter 02┃ Basic Product Functions Firmware Update Firmware Update 1 Download the firmware from the following website. Remove the Micro SD card from the device and use a card reader to 2 connect with the PC. Back up data currently in the memory card separately and format the 3 memory card. 02 Basic Product Functions 4 Copy the downloaded firmware into the SD card. 5 Insert the SD card with the firmware copied and turn the power on. COPY At such time, the red LED will remain on.
Chapter 02┃ Basic Product Functions Key Product Features Key Product Features 1. 720P HD Resolution Real Time Recording Within the HD (1280 x 720) resolution of the 16:9 WIDE screen, recording is conducted up to max 30 frames. A 2-million resolution camera suited to HD resolution has been equipped. Navigation systems and external monitors can be connected to be display live video . 3. Voice Recording Sounds are recorded through the built-in microphone.
Key Product Features Chapter 02┃ Basic Product Functions Various Recording Features 8. Various Recording Features Continuous Recording 02 Basic Product Functions 14 Normal video files are saved starting from device turning on until turning off. If the data exceeds the capacity of the Micro SD card during continued recording, files are sequentially deleted starting with the oldest file in order to record new videos.
How to Operate the Product Chapter 02┃ Basic Product Functions Operating the Product Power ON After product installation, if the vehicle power or the ignition is turned on, the red / green LED is alternately displayed and then after about 10 seconds, and then the red LED will blink twice, and then the LED will blink as green and the ‘Starting recording’ voice guidance will sound to indicate that recording is starting in infinite recording mode.
How to Operate the Product Chapter 02┃ Basic Product Functions Operating the Product Event Recording An accident, sudden braking, sudden acceleration, sudden turn, or some other form of impact on the vehicle is detected by the built-in sensor. The ‘Bee Beep’ voice guidance will sound and the red /green LED will blink alternately to indicate that an event video is being recorded. Once event recording is complete, the device will automatically convert back to infinite recording mode.
Chapter 02┃ Basic Product Functions How to Operate the Product Voice Guidance on Product States and LED Display State Operating State Button Operation RED LED GREEN LED Power ON Power turned On - After ON for 0.
Chapter 02┃ Basic Product Functions How to Operate the Product Voice Guidance on Product States and LED Display - 2 State 02 Basic Product Functions 18 Operating State Button Operation RED LED GREEN LED Voice Guidance Voice Guidance Beep Eject Micro SD When ejecting Micro SD - Normal blinking OFF “Storage is not checked.
Chapter 02┃ Basic Product Functions How to Operate the Product Voice Guidance on Product States and LED Display - 3 Voice Guidance Operating State Button Operation RED LED GREEN LED When connecting rear view camera When connecting rear view camera - - - “Rearview recording is selected” “Ddililing(↑)” When disconnecting rear view camera When disconnecting rear view camera - - - “Rearview recording is released” “Ddililing(↓)” System Error When camera and recording device reset has failed
Chapter 02┃ Basic Product Functions Checking through the Micro SD Card 1. Eject the Micro SD card from the device and use a card reader to connect with the PC. 2. Once connected with the PC, a removable disc will be started. 3. As shown in the figure, pressing “open folder to view files” will display the folder.
Checking through the Micro SD Card Chapter 02┃ Basic Product Functions 1 Record : Folder with recorded files • • • • As folder in which recorded video files are saved, includes Front/Rear folders. Front folder : Folder where front camera video files are saved Rear folder : Folder where rear camera video files are saved Front/Rear folders include Infinite/ event/ parking/ parking event/ manual files. 2 sys_data.
Installing the PC Viewer Chapter 03┃ PC Viewer Features 1) double click the G660 CarcamPCViewerSetup file. 4) To continue, click “Next”. To save as a different name, enter the desired name. 2) In the installation window, click “Next” to start installation. 5) Check the desired icons you want to create and click “Next”. 3) Designate the folder where you wish to save. If there are no changes, click “Next”. 6) Once the installation setup is complete, click “Install” to conduct installation.
Installing the PC Viewer Chapter 03┃ PC Viewer Features 1) To install Microsoft Visual C++ 2008 Redistributable, click “Next”. 03 3) Check the “I agree” box and click “Install”. 4) After installation is complete, click “Finish”. PC VIEWER Features 2) Click “Next”. 5) Once the PC Viewer is properly installed, the G660 CarcamPCViewer and PCViewerConfEditor shortcut buttons will be displayed on your desktop.
Chapter 03┃ PC Viewer Features PC Viewer Features 5 1 Main Control 1 2 Play Control 3 File List & Accelerometer Information 4 Map 03 5 Setting Button PC VIEWER Features 2 Information : PC Viewer image and functions may partially change with future updates. 4 3 24 1. Main Screen Recorded files in file list are shown simultaneously as 2CH video. Increase Playspeed (-5~+5) Play previous file Play/Pause (Toggle) Play position Move in Frame units (forward direction) Volume control 2.
Chapter 03┃ PC Viewer Features PC Viewer Features 3. File List 1) Add Video Files 3) Select Video Type When the right-side mouse button is pressed within the fie list title area, the selection menu shown below is displayed. The file list is sorted in ascending order. 2) Delete Video Files ① Use the ‘-’ button to delete ② Use the DEL key to delete Information : PC Viewer image and functions may partially change with future updates.
Chapter 03┃ PC Viewer Features PC Viewer Features 4. Partial Video Zoom-In 03 PC VIEWER Features 26 5. Full Screen Mode 1) Partial Video Zoom-In Select the area to zoom-in on by dragging with the mouse. The zoom-in area is shown on the opposite side. If the area is not properly selected, then video zoom-in is canceled. 2) Cancel Partial Video Zoom-In Within the zoom in video, right-clicking with the mouse will cancel video zoom-in. 6.
Chapter 03┃ PC Viewer Features PC Viewer Features 7. Map 9. Video Capture Upon clicking, the play position will jump to the selected position to begin playing. Jump play the same role as the play progress bar. 10. Defog If GPS information exists within the video, then the map is displayed at the bottom right side. While playing, clicking the video capture button will save or print the current screen. Feature used to capture current screen and make the image clearer.
Chapter 03┃ PC Viewer Features PC Viewer Features Configuration For your convenience, the function of the black box is a program to easily configure the settings. • Recording Settings : Recording-related functions should set. • Camera Settings : Camera-related functions should set. • Parking Setting : Parking must set mode-related functions. • ETC setting : Other settings should function • Viewer settings : PC Viewer-related functions should set.
Chapter 03┃ PC Viewer Features PC Viewer Features Camera 1. Video Resolution : HD(1280 * 720) 1. Brightness : Sets Camera Brightness 2. Infinite Video Quality : Set infinite video quality 2. Contrast : Sets Camera Contrast 3. G-Sensor Sensibility : Sets event sensitivity during infinite recording 3. Sharpness : Sets Camera Sharpness 4. Audio Input Volume : Adjusts volume upon recording (when set to 0, sound is not recorded) 5.
PC Viewer Features Parking 03 PC VIEWER Features 30 1. Parking Video Quality : Sets parking video quality 2. Parking Event Mode : Sets whether to detect events during parking recording 3. Impact Event Sensibility : Sets impact event sensitivity during parking 4. Motion Event Sensibility : Sets motion event sensitivity during parking recording 5. Parking AE Gain : Adjusts the AE Gain level during parking recording 6.
Chapter 04┃Product Specifications Product Specifications Category Specifications CPU MV8670 Product Classification Front HD 30fps, Rear HD 30fps 2Chs Black Box Color/Size/Weight Black / 79mm x 53mm x Ø30mm Supported Capacity micro SD Camera Viewing Angle 8GB / 16GB / 32GB Maker : ADATA, Class 10 recommended 2M HD CMOS Sensor Diagonal 120 degrees/ Horizontal 88 degrees / Vertical 53 degrees Resolution 720p HD(1280 x 720) Based on Front Camera.
Chapter 04┃Product Specifications Product Specifications Category Specification Infinite Recording Infinite Mode Recording Method Parking Mode 04 Product Specifications 32 Event Recording (Impact / Manual) Parking Recording Parking Recording (require extra power supply) Event Recording (Impact / Motion) Event Only Recording (Impact / Motion) When power is turned OFF, saves currently recording video Video Saving MOV (Video: H264, Audio: ADPCM) Interface GPS / Video Out (TV out ) / Video In (rear
