Operating instructions

Analog S 1-channel audio signals can be output from the DVD-3800
The multichannel audio signals recorded in packed PCM can be played when an AV amplifier equipped with
analog 5 l-channel audio inputs is connected
To powe outlet
Set the "AUDIO SETUP" default setting as shown below (See page 18)
• "DIGITAL OUT" _ "PCM"
"LPCM (441 kHz / 48 kHz)" _ "ON"
Playing DVDs with incorrect settings may resulL noise that codd damage your ears or the speakers
DVD-3800
@@@@
75 _/o/ms pM plug came (commercially ava lable}
]
® i _OODDD
Digita audi° nput l
CO/nector (OPTICAL Digital audio
input
connector
(COAXIAL}
inputterminals
NOTES:
FO_ _T_t _c_lne_ cor_r_ectlor_s r set UAUD_O CHANNEL '_ _nde_ r'AUDIO SETUP" at "SETUP r' to "MULTI
CHANNEL" and make the "SPEAKER CONFIGURATION", "CHANNEL LEVEL" arid "DELAY TIME"
settings
• Set "LPCM (441 kHz/4g kHz)" under "AUDIO SETUP" at "SETUP" to "OFF" (See page 18)
(If set to "ON", analog audio signals converted to 96 kNz/S8 2 kHz will be output when playing sources
recorded at 196 kHz/176 4 kHz)
• When playing DVDs that are not copyright-protected and the unit is set to output digital and analog audo
signals simultaneously, for some discs only the signals below 96 kNz for the front two channels will be
output for the analog part
When playing DVDs that are nol copyright-protected, set "DIGITAL OUTPUT" at "PURE DIRECT MODE"
to "OFF" (See page 23)
• When playing DVDs recorded in MPEG audio format, the audio s gnals are down-mixed to 2 channels for
output
• With the DVD-3800, we recommend turning the digital output off and only outputting analog signals in
order to keep interference from the digital output circuitry to the minimum and allow you to enioy high bt,
high sampling frequency, high quality multi-channel sound
DVD-3800
'I[;
s/Sts
®,®,@
NOTES:
• When connecting to a 2-channel audio stereo device, set "AUDIO CHANNEL" under "AUDIO SETUP" at
"SETUP" to "2 CHANNEL" {see page 17) For multi-channel sources, the signals are down-mixed into two
channels (analog) (Only the front left and right channels are output for sources for which down-mixing is
prohibited)
• Set "LPCM (441 kHz/48 kHzl" under "AUDIO SETUP" at "SETUP" to "OFF" (See page I8)
(If set to "ON", analog audio sgnals converted to 48 kNz will be output for linear PCM or packed PCM
sources)
• Set "DIGITAL OUTPUT" at "PURE DIRECT MODE" to "OFF" (See page 231
(If set to "ON", analog audio signals converted to 96 kHz/88 2 kHz will be output when playing sources
recorded at 196 kHzJ176 4 kHz)
9