User's Manual

Astera LED Technology GmbH
User Manual for AX5 TriplePAR™ 2017-09-08
Page | 14
4 SPECIFICATION
LED power:
45W
Illuminants:
3 x 15W RGBAW Philips LEDs
Luminous Flux*:
1080Lm (bei Weiß 3200K)
Emittance*:
4800lx (2m; Weiß 3200K)
Beam Angle:
13°
Input Voltage:
90-264V 47-63Hz 1.8A/115VAC 1.0A/230VAC
Inrush Current:
COLD START 70A/230VAC
Battery Runtime:
up to 20hrs (seamless runtime)
Wireless Module:
EU: 868.0-869.7 MHz
US: 902-928 MHz
2.4 GHz
Operating Temperature:
0°C – 40°C
32°F – 104°F
Relative Humidity:
0%-100%
Size with bracket:
Size without bracket:
L148.1mm x W193.6mm x H213.5mm / 5.83” x 7.62” x 8.40”
Ø153.2mm x H140.5mm / Ø6.03” x H5.53”
Weight:
3.40 kg
7.5lbs
IP Rating:
IP65
* Typical Values
5 TROUBLESHOOTING
The fixture does not turn on.
The battery may be empty. Connect it to the AC and try again.
The fixture turns on and the display is on, but the LEDs do not emit light.
The fixture could be set to BLACKOUT mode, set to display black color or is operating in DMX
mode and doesn’t receive a valid signal. It is good practice to do a RESET SETTINGS (Chapter
6.21) between setups.
The fixture is not working correctly - it does not display the color or effect chosen.
The fixture may still be operating under a previous setting. It is good practice to do a RESET
SETTINGS (Chapter 6.21) between setups.
After completing a RESET SETTINGS, the fixture still cannot be controlled by AsteraApp™.
Make sure the RADIO PIN (Chapter 6.20) of the fixture and AsteraApp™ is the same.
The fixture does not run long enough on battery.
The required RUNTIME can be set. It defaults to 5h. To achieve a greater battery runtime, set
the RUNTIME to the required value. Alternatively, program the fixture to only display colors
that use less power, such as Red, Green and Blue.
If the runtime is still too short, consider that it is reduced slightly if the battery is very cold.
The power cable is connected but the fixture is not charging.
The battery may be fully charged. Refer to chapter 3.5.1 for more details. The fixture will only
commence charging when its battery has a temperature of 45° or less. Turn the fixture off and
let it cool down; once cold enough, it will start charging. If it still not charging, consult our
website.