User's Manual

Astera LED Technology GmbH
User Manual for AX5 TriplePAR™ 2017-09-08
Page | 31
6.20 INFO
Read/set the RADIO PIN. To
change the pin, press ENTER.
Adjust each digit with the + and
– keys, cycle through the digits
with the MENU key. When
finished, press ENTER again.
Tells the serial number of the
light and the CPU type (43xx).
The firmware version and
hardware version of the light.
The hour-counter is counting up
as long as the light is powered
up. It does not count if the light
is powered off and charging.
While the light is receiving an
UHF signal, this tells the signal
strength and deviation.
The current charging state of
the battery in percent.
Gives information about the LED
calibration stored in the light, for
service reference only.
6.21 RESET SETTINGS
Return the light to the default
settings. This may be done
before each use to start from a
known point. The RADIO PIN
and the CRMX pairing stay.
HINT
It is highly recommended to reset the light’s settings after each event to ensure a clear start
for the next usage.
Main menu:
INFO
Radio PIN:
0000
Serial number:
000-00000 43xx
Firmware version
5.2.20.U HW001
Power-on hours:
00001h
RF link:
-36.0dBm -0.0ppm
Battery state:
100%
Calibration:
2015-04-20-0001
Main menu:
RESET SETTINGS
ARE YOU SURE?
NO YES