User's Manual

Astera LED Technology GmbH
User Manual for AX5 TriplePAR™ 2017-09-08
Page | 43
7.14 ENTER AND LEAVE STANDBY
The standby is intended to be used between setup and event (see chapter 3.5.1Error! R
eference source not found.). After setup is completed, all lights may be switched to standby
mode and woken up later when the event starts. This ensures that no battery runtime is
wasted. This can be either done manually or automated.
Press the small arrow to
open the standby menu.
By pressing the “Now”
buttons, standby can be
switched on or off for all
currently targeted lights.
Any of the “Later” buttons
will require a time to be set.
The standby will be
scheduled to the specified
time.
NOTE:
While you are using the “Now” function, only those lights that are currently targeted are
addressed (see chapter 7.5 how to target lights).
The “Later” function always sends to the “All Lights” target!