User manual

Setup

Introduction

The Setup is used to set up the lights, rather than the ART3 itself. It offers advanced settings that can

be used before or after an event like factory reset, forming groups of lamps, setting a light’s DMX

address etc. To get to Setup, see bottom of page 5.

Settings

The following settings can be adjusted. After changing the settings all lights in range will blink in

white light once a second. Press the Enter or on/off button of the lights to confirm on which lamps

you want to execute this setting. Here is a hierarchical tree of the setting along with a short

description. For a complete list that explains each setting, please refer to the ARC2 manual.

Create a Set: A set is a cluster of lamps with fixed positions that can be targeted at the same time.

Create a Chain: Use a chain to stretch effects over several Sets

DMX Setup: Send a number of DMX settings to lamps that do not have a display

DMX Address: Sets the DMX address of the desired light

DMX Pixels: Sets how many pixels a light has (all, one or reduced pixels)

DMX Tab: Several different DMX tables can be chosen to select what channels are used to

control the lights (RGB S RGB S, RGB RGB S S, Effect Mode Fix, Effect Mode RGB)

Strobe: Sets how many channels are used to control each pixel’s strobe

DMX Failure: Sets the behavior of the light in case of an interrupted DMX signal.

Remote Setup: Send a number of settings to lamps that do not have a display

Remote Group:Defines the group in which a lamp is

Input Select: Defines which signal a light listens to (XLR, wireless DMX, remote, standalone)

AC Failure: Sets the behavior of battery powered lights in case of power failure

Manual Wht Calib: Allows you to calibrate the RGB levels to match other white LED lights

Test Radio: A test to check the distance of lights and ART3 to see if the antenna is defect

Radio Pin: The Radio Pin sets the frequency and makes it possible to operate several lights and

controllers without them influencing each other. Controllers and lights must have the

same radio pin in order to work with each other.

Factory Reset: Factory Reset puts the ART3 or a lamp into its original state and deletes all settings.

The only setting that is not influenced by Factory Reset is the Radio Pin