User manual

RGB S RGB S..: For each pixel there are three
channels RGB and one channel stroboscope.
RGB RGB S S..: All RGB channels are followed by
all stroboscope channels.
Effect Mode Fix: The 4 user colors are controlled
by one channel per color (generates basic colors).
Effect Mode RGB: The 4 user colors are controlled
by three DMX channels each.
Strobe: Single: One DMX channel is supplied for the con-
trol of the stroboscope function and all
pixels will strobe Identical. When using
this setting, DMX TAB should not be set
to RGB S RGB S ..
Multiple: For each pixel, the stroboscope can be
controlled individually.
Off: Stroboscope is turned off globally.
DMX Failure: Sets the behavior of the light in case of an interrupted
DMX signal.
Hold: The output keeps unchanged, the last
received DMX frame is displayed.
Emergency Light: If the DMX reception times out,
the light turns white.
Blackout: If the DMX reception times out, all light
turns black.
Remote Setup: Usually all configuration settings, like changing the DMX address,
chain configuration and so on is done directly on the units. This might
not be feasible if several units with the same settings have to be con
figured with the same settings or a unit is not equipped with a LCD-dis
play.
Remote Group chooses one of the 4 groups. Input Select lets
you choose between XLR DMX, Wireless DMX,
Remote Control function. Standalone or Auto.
Input Select If a lamp has several input signals (for example it is
connected to a DMX cable but should be targeted
by the ARC2) the preferred input signal can be
defined
XLR DMX for the signal of wired DMX
Wireless DMX for the signal of wireless DMX
Remote Control for the radio signal of the ARC2
12