Installation & Assembly

WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER .
ASSEMBLING THE FIXTURE (Fig.2).
1. Return the arms to suitable position, see figure.2. Slide the
cover(L) and down
flush to arms of the fixture body(F),tighten it
with the finial(K) .
2. Pu
t
the socke
t
sleeve (H) onto the lamp holde
r
. Attach the cove
r
(I)
onto the sleeve.
3. Attach the lobation crystal(M) an
d
crystal cluster(J) to the en
d
small
ring of the arms. Attach the crystal ball(N) to the bottom small ring
of the finial. Attach the crystal ball(E) to the center small ring of the
fixture body's frame.Attach the crystal ball(G) to the middle small
ring of the finial.
4. .Install the ligh
t
b
ulbs in accordance with the fixture specifications
NOTE: DO NOT EXCEED THE SPECIFIED WATTAGE!
HANGING THE FIXTURE (Fig.1)
1. Shu
t
off the
p
owe
r
a
t
the circui
t
b
reake
r
an
d
remove old fixture
from ceiling, including the old single bar.
2. Carefully unpack new fixture and lay all the parts on a clear
surface.
3. Threa
d
the two mounting screws abou
t
1/4" into the
p
re-drilled
holes in the mounting plate, spaced about the same distance apart
as the holes in the fixture back plate. Attach the mounting plate to
the junction box using two junction box screws. The side of the
mounting plate marked "GND" must face out.
4. By measuring, determine correc
t
numbe
r
of links neede
d
fo
r
proper hanging height. Using proper chain pliers disconnect and
discard remaining chain, connect to the fixture loop. Close the
link(B).
5. Lace the fixture wires through the chain.
6. Open the other end link of the chain and hang the fixture on the
loop at the ceiling. Close the link(B).
7. Fee
d
the fixture wires through the loop an
d
p
ull until taut.
8. Slide canopy(A) up flush to ceiling, lock it securely with ball
nut(C). Attach the crystal ball(D) to the bottom finial of the
canopy(A).
CONNECTING THE WIRES (Fig.3)
1. Take the black wire from the ceiling junction box and the smooth
wire leg from the fixture and twist bare ends together. Twist wire
connector onto end of wire until snug.
2. Repeat same process with white junction box wire and ribbed wire
leg of fixture wire. NOTE: Twist wires together in the same
direction you twist the wire connector onto wires.
3. If your junction box has a grounding wire (green or bare copper),
attach this wire and the bare copper wire from the fixture together
as step 1.If junction box has no ground wire, attach the bare copper
fixture wire to the green ground screw on the single bar.
4. Tuck these wire connections neatly into the ceiling outlet box and
then raise the canopy (A) all the way to the ceiling, lock it securely
with ball nut(C).
Your installation is now complete. Return power to the junction
box and test the fixture.
Fig.1
Green Screw
(GND)
Fig.2
E
F
G
H
I
M
N
J
Fig.3
White or
HOUSE
Black
WIRES
(Hot)
Smooth
FIXTURE
WIRES
Black or
Ribbed
WIRES
FIXTURE
Bare Copper(Ground)
FIXTURE
WIRES
Copper
(Ground)
HOUSE
(Neutral)
WIRES
White
Bare
Green or
WIRES
HOUSE
Listed
U
L
R
ASSEMBLING & INSTALLATION INSTRUCTIONS