Installation & Assembly

6of7
STEP 10 - Assemble Strut Member and Finial
A. Remove the Strut Member and the Nipple from the Finial.
B. Screw one end of the Nipple into the Hex Coupling on the
bottom center of the Fixture Body (F). Hand tighten until
snug.
C. Pass the Strut Member over the top end of the Nipple and
secure with the Finial. Hand tighten until snug.
Figure 11
Hex Coupling
Nipple
Strut Member
Finial
Fixture Body
STEP 11 Apply Silicone Sealer to Mounting
Balls
-
A. To prevent moisture from entering the wire
compartment, apply a small amount of silicone sealer
(not included) to the threaded side of the mounting
balls (E) and then install them onto the mounting
screws (B). Wipe off excess caulk.
Figure 12
Mounting Ball
STEP 9 Attach Glass Frame to Fixture Hood-
A. Place the Glass Frame over the end of the Stem on the
bottom center of the Junction Box. Attach to the Fixture
Hood. Secure by threading the Hex Coupling onto the
Stem and tighten until snug.
Fixture
Hood
Stem
Junction Box
Glass Frame
Hex Coupling
Figure 10
Assembly Instruction