Installation Instructions

WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER .
Fig.1
Fig.2
MOUNTING THE FIXTURE
1. Shut off the power at the fuse box or circuit breaker box.
Remove the old fixture from ceiling, including the
crossbar.
2. Carefully unpack your new fixture and lay out all the parts
on a clear area. Take care not to lose any small parts
necessary for installation.
3. Thread the two Mounting Screws (A) about 1/4”into the
pre-drilled holes in the Crossbar (B) spaced about the
same distance apart as the holes in the fixture body (D).
Allow screws (A) to protrude slightly beyond the ceiling
surface.
4. Attach the crossbar (B) to the outlet Box using the two
screws (C) from the outlet Box. The side of the crossbar
marked "GND" must face out.
5. Hold the fixture body (D) towards the crossbar and
connect the electrical wires as follows (See Fig.2).
Connect the black wire from the fixture to the black house
(hot) wire; connect the white wire from the fixture to the
white house (neutral) wire. Make sure all wire nuts are
secured. You may wrap the connections with electrical
tape.
If your outlet box has a ground wire (green or bare
copper) connects fixture’s ground wire to it. Other wise
attach the bare copper fixture wire to the
green ground
screw on the crossbar. Tuck the wire connections neatly
into the ceiling junction box as you are holding the fixture
assembly toward the ceiling.
6. Finish mounting the fixture body (D) by placing it over
both Mounting screws (A) so that the screws protrude
from the keyholes in the bottom of the fixture body (D).
Rotate the fixture body (D) until the screw are seated in
the slots of the keyholes and tightened it with a
screwdriver.
7. Place the tube (E) over the socket of the fixture body (D).
8. Install the light bulbs in accordance with the fixture’s
specifications. DO NOT EXCEED THE MAXIMUM
WATTAGE RATING!
9. Attach the finial(F) to the bottom of the fixture body (D).
Your installation is now complete. Return power to the
junction box and test the fixture.
MIN 90℃ SUPPLY CONDUCTORS
White or
HOUSE
Black
WIRES
(Hot)
Smooth
FIXTURE
WIRES
Black or
Ribbed
WIRES
FIXTURE
Bare Copper(Ground)
FIXTURE
WIRES
Copper
(Ground)
HOUSE
(Neutral)
WIRES
White
Bare
Green or
WIRES
HOUSE
INSTALLATION INSTRUCTIONS
For Flush Mount Ceiling Fixtures